Briggs & Stratton 040298, Service & Troubleshooting Manual

Page: 64 / 68

60
3
3
Figure 23
Figure 24
3. Use a plastic, dead blow hammer to evenly seat
stator into the adapter casting.
Assemble the Alternator
1. Pull wires up through rear bearing carrier ( A , Figure
25). Set rear bearing carrier on rotor bearing and
stator. Verify second roll pin slot (
B , Figure 26) in
stator lines up with roll pin ( C ) in rear bearing carrier.
Figure 25
Figure 26
2. Using a plastic, dead blow hammer, tap rear bearing
carrier evenly over rotor bearing and stator until it
seats.
NOTICE: Do not use stator bolts to draw assembly together.
3. Insert stator bolts into each hole around the rear
bearing carrier. Tighten bolts in a criss-cross pattern
until snug, then torque to 40 lb-in. (5 Nm).
4. Rotate engine flywheel by hand slowly to ensure that
the alternator is not binding.
Continue Engine/Alternator assembly in reverse order of
removal.
Not
for
Reproduction