Briggs & Stratton 040298, Service & Troubleshooting Manual

Page: 11 / 68

7
1
1
To remove roof:
Remove the four screws and lift off ( A , Figure 2). Reinstall
roof in the reverse order.
Figure 2
To remove access cover:
Remove two screws, tilt cover out, and lift cover off panel ( A ,
Figure 3). Reinstall cover in the reverse order.
Figure 3
To remove side panels:
1. Remove roof.
2. Remove screws at base of enclosure and along the
side of the control panel ( A , Figure 4).
Figure 4
3. Pull panel outward (away) from unit while pulling
panel upward and out of base.
To install side panel:
1. Guide bottom of panel into base.
2. Push panel until flush with sides.
3. Replace panel screw(s).
4. Replace roof and screws.
To open access door:
1. Insert key into lock of access door handle and turn
key one quarter turn clockwise (Figure 5).
Figure 5
2. Grasp door handle and turn one quarter turn
counterclockwise to open. Remove key.
To close access door:
1. Close door and turn door handle one quarter turn
clockwise.
2. Insert key into lock of door handle and turn key one
quarter turn clockwise. Remove key.
WARNING Contact with the muffler area can result in
serious burns. Exhaust heat/gases can ignite
combustibles or structures causing a fire.
• DO NOT touch hot parts and AVOID hot exhaust
gases.
• Allow equipment to cool before touching.
Not
for
Reproduction