Bridgeview BALE KING 7400, Operator'S Manual, Page: 38 / 102

Bridgeview Manufacturing Inc.
Page 34
Twine Removal
It is natural that twine that has been removed from the bales will wrap around the rotor. The patented
“X” shape makes twine removal much easier. It is recommended to remove the twine from the rotor
every 10-15 bales to avoid having so much that it begins to hinder the flail movement. The more often
this is done, the easier it is to remove, since the twine has not had a chance to wrap more tightly.
To make this process even easier, an access door is available for easy access to the rotor. This
is found on the left side of the machine and is opened and closed using the over-center latch at the top
of the door. Always make sure this door is properly closed while operating.
WARNING : Before attempting the removal of twine from the rotor, be sure that the machine
is stopped and the tractor is shut OFF . Place the tractor in park. Twines can be removed with the use
of any knife. Cut the twine/net along the full length of the rotor, then pull this twine out of the machine
and dispose of it.
An electric device is also available from suppliers to melt the twine & allow it to be pulled off.
Twine/net combined with hay dust is extremely flammable. NEVER leave the machine unattended
until all twine, dust, and embers have been removed. It is NOT PERMITTED to leave the twine
burning on the rotor as this has several adverse effects:
•
It may take the temper out of the steel, rendering it weaker.
•
Loose straw and hay remaining in the machine may ignite causing a fire in the processor.
•
Excessive buildup of melted plastic.
•
Dry out bushings causing them to wear prematurely.
NOTE: Bridgeview Manufacturing Inc. VOIDS warranty for any damage caused by twine
burning in the processor.