BriarTek Orca DF-101, User Manual And Installation Manual

Page: 16 / 24

16
7.5 Troubleshooting
Problem Possible Cause(s) Solution(s)
System does not turn on “Power On” button is not
pressed for required amount
of time. Press “Power On” button for
at least one second
Power surge Ensure direction finder is
plugged into energized power
source.
Inspect in-line fuse and
replace fuse if blown
Improperly assembled power
cable Check power cable for
continuity
System not energized Verify breaker(s) and
switch(es) are turned “ON”
Water has penetrated the DF
display housing Check for corrosion on
DB9 connectors on back of
display. If corroded, contact
manufacturer.
Display continuously points
to the same bearing An emitter from ownship or
another ship is radiating at
121.5 MHz. If possible, energize another
DF to determine source of
transmission.
Damage to the cable jackets
or leads Check data cable for
continuity.
Inspect the entire length
of the cable for cut/frayed
wire(s).
Water penetration in the
antenna housing Check for corrosion on DB9
connector at the base of the
antenna. If corroded, contact
manufacturer.
DF-100 display is connected
to DF-101 antenna Replace DF-100 display with
a DF-101 display
Indicator displays errant
bearings Antenna is not installed with
correct orientation. Orient antenna so arrow on
housing is pointing forward.
Ensure all elements are
attached and secure.
Interference from an
emitter other than a MOBI
transmitter. Press the Squelch Increase
button.
continues »