40
BIAC User Manual Installation
1
2
3
4
5
6
be plugged into the NEMA 5-15
receptacle on the ETC).
Setup B (Figure 49): If the Chiller
compressor is plugged into the
ETC chilling receptacle, the Chiller
pump should be plugged into the
IEC 320 receptacle on the front
of the Chiller (near the manual
thermostat).
In most situations for tanks
<100L/24gal, Setup B is
recommended, as it allows
the water bath temperature to
be closer to the fermentation
temperature, and it will reduce
electrical consumption. (Cycling
frequently is hard on the
compressor, so if the compressor
is turning on/off every few
seconds, Setup A is preferred.)
Replacing the connectors
Connecting
7. Push the tube into the fitting firmly (about 1.5 cm).
The tube must be cut straight to avoid any imperfect
connections. If the tube can’t be inserted, moisten the
end and try again. (See Figure 50)
Disconnecting
8. Hold the grey ring towards the body of the fitting
and pull out the tube. (See Figure 50)
Regular and scheduled maintenance
Regarding routine maintenance, the
information contained in this manual is
41
Figure 49
Figure 50
Summary of Contents for BIAC
Page 1: ......
Page 45: ...BIAC User Manual 44...
Page 56: ...Brewing 1 2 3 4 5 6 55 Notes...
Page 57: ......