Printed in USA © 2015
5
Document # 2102861 RevA
Brewer
FLEX
Access
Exam Table
Overview
Perform the following sequence in order when setting up
the table:
• Uncrating the table
• Leveling the table
• Adjusting Rear Base Extension
• Installing Power Cord
• Installing Foot Control
• Installing Grab Bars
Tools Required
Drill Driver, 7/16” socket bit, or 7/16” wrench, 9/16”
wrench, #2 Phillips bit, side cutter and furniture dolly.
Uncrating
1. Remove stretch wrap surrounding table.
2. Remove the 4 steel shipping brackets securing the
table to the pallet (Figure 2). The brackets hook onto
the table levelers to hold the table securely to the
pallet. Remove the 2 bolts from each bracket using
a 7/16” socket or wrench. Take care not to scratch
the unit when using the driver or turning the wrench.
Remove brackets from levelers once bolts are
removed.
3. Remove the 2 screws attaching the spacers on either
side of the wooden U-shaped brace located under the
front corners of the cabinet (Figure 3). Remove the
2 screws attaching the U-shaped brace to the pallet
(Figure 3).
Proper Handling
To avoid injury and damage to the table, handle only
as indicated in Figures 2 through 16. Do not handle as
shown in Figures 8 through 10.
NOTICE
Grab Bar Option
If your table was purchased with the Grab Bar option,
remove the box from the back of the pallet.
NOTICE
INSTALLATION
No Sharp Tools
To avoid damaging the table’s
upholstery or painted surfaces, DO
NOT use a knife or other sharp object
to open the packaging.
NOTICE
Avoid Self Activation Damage
Plugging table into receptacle prior to
the removal of all packaging materials,
may cause damage if self activation
occurs.
NOTICE
NOTICE
Inspect Carton and Contents
Inspect all boxes and contents for
damage. Report any damage to the
carrier immediately.
Figure 2. Remove Shipping Brackets
Figure 3. Remove Spacer and U-Brace Screws