Printed in USA © 2015
15
Document # 2102861 RevA
Brewer
FLEX
Access
Exam Table
OPERATION (continued)
Paper Roll Holder
To change a paper roll, remove old paper roll tube,
place the paper holder rod into the paper roll tube,
and place into paper roll holder”J-Hooks” located on
the rear of the seat back (Figure 28). Pull the end of
the roll over the top of the seat back and place in the
desired position.
Figure 28. Paper Roll Installation
Uses Paper Rolls
18” by 3.5”
or
21” by 3.5”
Removing the Work Surface for Cleaning
1. Push work surface in, to reveal a white plastic stop
screw.
2. Remove the white plastic screw (Figure 30).
3. Pull the work surface toward you and remove it.
4. Reinsert screw after replacing work surface.
Figure 30. Location of White Plastic Stop Screw
Plastic Screw
Work Surface
Pass Through Work Surface (Optional)
A pass through work surface, stored under the seat
(Figure 29), may be pulled out from either side of
the table. Grasp the edge of the work surface and
pull until it is fully extended. Push it fully in to stow
after use.
Figure 29. Pass Through Work Surface
Fall Hazard
The work surface is rated for 15 lbs. and
is not intended for use as a seat. Sitting
on work surface could cause it to bend or
break or cause the table to tip creating a fall
hazard leading to injury.
CAUTION