Brewer
FLEX
Access
Exam Table
Printed in USA © 2015
10
Document # 2102861 RevA
Figure 18. Grab Bar
Figure 17 Foot Control and Power Cord Receptacles
INSTALLATION (continued)
Installing Grab Bars (Optional)
1. Remove grab bars from the carton banded to the
pallet.
2. Grab bars are interchangeable and may be
installed on either side.
3. Align pin on grab bar shaft with mating slot on side
of table. See Figure 18.
4. Push grab bar all the way down and rotate to front
of table.
5. Push grab bar down until it engages to prevent left
or right movement.
Grab Bar
Pin
Mounting Support
Power Cord
Inlet
Foot Control
Receptacle
Installing the Power Cord
1. Remove the power cord from the front drawer.
2. Insert the female plug end of the power cord into
the receptacle on the table (Figure 17). Make
sure the plug is fully seated.
Installing the Foot Control
1. Remove the foot control from the front drawer.
2. Insert the male plug of the foot control cord into
the receptacle on the table (Figure 17). Make
sure the plug is fully seated. See Figure 6 for
proper insertion of the foot control plug. Failure
to properly insert the foot control plug can cause
some functions to not operate properly