Care and cleaning
11
•
Before cleaning the deep fryer, always make sure
the unit is disconnected from the power outlet.
•
Make sure the unit and oil are completely cool.
Do not attempt to move or carry the deep fryer,
element and control assembly while it is hot
•
Wash the basket in hot soapy water.
Dry thoroughly.
•
Remove the control assembly of the deep fryer by
lifting upwards (see fig 5).
•
Grasp each side of the removable bowl and lift
upwards (see fig 6).
•
Empty the bowl of cooled oil. As oil can be re-used
several times (depending on type of food cooked),
filter the oil through a fine sieve (such as a new
chux cloth).
•
The removable stainless steel bowl allows for easy
cleaning. Wipe down the bowl with absorbent
paper, then a damp cloth and a little mild
detergent. Finally wipe the bowl with a clean damp
cloth and dry with a clean dry cloth.
•
Wipe over the controller assembly and element
with a damp cloth and a little mild detergent.
Finish off with a clean damp cloth followed by a
clean dry cloth.
•
The removable bowl, frying basket and outer body
are dishwasher safe.
•
Wipe over the outside of the unit with a damp
cloth and a little mild detergent. Finish off with a
clean damp cloth followed by a clean dry cloth.
•
Reassemble unit for storage.
Operating your Breville Deep Fryer
continued
Cool zone technology
The submerged heating element system on the
Avance Forte Deep Fryer allows oil to be heated
more effectively, and respond quickly to oil
temperature changes.
Oil below the heating element is cooler and allows
cooked foods including crumbs to sink to the bottom
of the stainless steel bowl and not cook any further,
tainting the oil taste.
This allows further cooking to take place without food
particles interfering or tainting the cooked result.
The Cool Zone Technology results in less need to
change the cooking oil. Used oil can be re-used more
times than in standard deep fryers.
Auto cut-out reset button
Always add the required amount of oil BEFORE
switching the power on at the power outlet. An Auto
Cut Out safety switch will be activated if the unit is
turned on without oil in the bowl.
To re-activate the unit, let the unit cool completely
and then reset by pushing the red button on the back
of the controller assembly above the cord storage.
10
COOL ZONE AREA
Fig 5
Fig 6
ALWAYS TURN THE APPLIANCE OFF, TURN THE POWER OFF AT THE POWER OUTLET AND THEN
UNPLUG CORD BEFORE ATTEMPTING TO MOVE THE APPLIANCE AND BEFORE CLEANING.
DO NOT UNDER ANY CIRCUMSTANCES IMMERSE THE CONTROL ASSEMBLY, THE SUPPLY CORD
OR PLUG IN WATER OR ANY OTHER LIQUID.
BR6482 BDF300 Booklet.qxp 23/12/04 11:35 AM Page 10
Summary of Contents for Avance Forte BDF300
Page 4: ......
