Breckwell BH32VF, Owner’S Instruction And Operation Manual

Page: 17 / 24

© 2021 Breckwell Hearth
17
MILLIVOLT CONTROL LIGHTING INSTRUCTIONS
1. STOP! Read All Labels.
2. Make sure the manual shutoff valve is fully open.
3. This heater is equipped with an ignition device (piezo)
which automatically lights the pilot. If the pilot will not
light using the piezo ignitor refer to the manual lighting
procedure.
4. Turn gas control knob clockwise to the “OFF” position,
set the thermostat to lowest setting and turn the ON/
OFF switch to the “OFF” position.
5. Wait five (5) five minutes to clear out any gas. Then
smell for gas, including near the floor. If you smell gas,
STOP! Follow “B” in the safety information label. If you
don’t smell gas, go to the next step.
6. From the “OFF” position, turn the gas control knob
counterclockwise to the “IGN” position. Push in the
control knob for (5) five second.
7. With the control knob pushed in, push in and release
the pieso ignitor button to light the pilot.
8. Continue pushing the control knob in for a further (60)
sixty seconds to prevent the flame detector from shutting
off the gas while the probe is warming up. Release the
control knob.
9. Turn the gas control knob counterclockwise to the “ON”
position.
10. After the pilot has been lit for one minute, the burners
can be turned on. Turn the On/Off switch to the “ON”
position and adjust thermostat to desired setting.
11. If the heater will not operate, follow the instructions “To
Turn Off Gas To Appliance” and call your supplier.
12. Wait (30) thirty seconds before readjusting the heater
when the control knob has been turned down to a
lower setting.
Pilot
OFF
ON
ST1179
on off switch
Control Cover Plate for Millivolt
Hi/Lo Control
Ignitor/Pilot
Control
On/Off Switch
(Located on Side of
Stove)
Pilot
OFF
ON
ST1179
on off switch
Control Cover Plate for Millivolt
Hi/Lo Control
Ignitor/Pilot
Control
On/Off Switch
(Located on Side of
Stove)
TO TURN OFF GAS TO HEATER
1. Turn gas control knob clockwise to the “OFF” position.
Do not force.
2. Turn On/Off switch to the “OFF” position and/or set
the thermostat (if present) to the lowest setting.
3. If applicable: Turn off all electric power to the appliance.
MANUAL LIGHTING INSTRUCTIONS
1. Open stove door. Remove any items necessary for easy
access to the pilot (for example: logs, screens, etc.).
2. Follow appropriate lighting instructions found
previously. Instead of pushing and releasing the piezo
button, light a match and hold the flame to the end of
the pilot and ignite the pilot.
3. After control knob has been released and pilot stays lit,
reinstall any items that were removed for pilot access.
4. Call a qualified service technician for repair or
replacement of the piezo ignitor.
CLEANING AND SERVICING
WARNING:
TURN OFF THE HEATER AND ALLOW TO COOL BEFORE
CLEANING. DISCONNECT THE ELECTRICAL POWER
BEFORE CLEANING OR SERVICING.
Annual inspection and cleaning by your dealer or qualified
service technician is recommended to prevent malfunction
and/or sooting. Remove logs, handle carefully by holding
gently at each end. Gloves are recommended to prevent
skin irritation from ceramic fibers. If skin becomes irritated,
wash gently with soap and water. Refer to manual for
correct log placement.
Periodic Cleaning
- See parts diagram for location of
items discussed below.
• Do not use cleaning fluid to clean logs or any part of the
heater.
OPERATION