BRAYER BR1107, Instruction Manual, Page: 12 / 76

12 EN
• Fill the container (16) with milk, do not exceed the
maximal level mark.
• Install the cappuccinator lid (14) on the container (16)
and install the cappuccinator back to the installation
place until the lock clicking.
• Install one of the coffee filters (19 or 20) into the filter
holder (18) matching the ledge on the filter (19 or 20)
with the hole on the holder (18) and turn the filter (19 or
20) counter/clockwise.
• Add the required amount of ground coffee into the filter
(19 or 20) with a measuring spoon (21) and slightly
tamp the coffee in the filter (19 or 20) with the back side
of the measuring spoon (21) (pic. 5, 6, 7).
• Install the filter holder (18) into the installation place «
» and turn the handle (4) to the right as far as it will
go « » (pic. 2, 3, 4).
• Place a cup of suitable height and capacity on the grid
(2) (see the table «CHOOSING THE APPROPRIATE
CUP»).
• Direct the cappuccinator pipe (13) into the cup using
the cappuccinator pipe angle adjustment bar (12).
• Turn the frothed milk supply (intensity) control knob (15)
to the right (in this position it produces more frothed
milk). Turn the frothed milk supply (intensity) control
knob (15) to the left (in this position it produces less
frothed milk) (pic. 8, 9).
Notes: you can adjust the milk foam supply intensity when
making cappuccino.
• Insert the power plug into the mains socket.
• Switch the coffee maker on by setting the power switch
(11) «0/I» to the position «I», the indicator (5, 6, 7) will
light up and start flashing.
• When the coffee maker is ready for operation, the light
indicator (5, 6, 7) will glow constantly.
• To make one cup of cappuccino use a small filter (19)
and press the «Cappuccino»-button (6) once; the light
indicator « » will light up.
• To make two cups of cappuccino use a big filter (20)
and press the «Cappuccino»-button (6) twice; the light
indicator « » will light up.
Note:
if you need to switch the coffee maker off during the
cappuccino making, press the button (6) «Cappuccino»
again.
• Remove the cup with the ready drink from the grid (2).
• After you finish using the coffee maker, switch the coffee
maker off by setting the switch (11) «0/I» to the position
«0».
• Wait until the coffee maker cools down, remove the filter
holder (18) and wash the filter (19 or 20).
• If there is some milk left in the cappuccinator, remove
the cappuccinator and put it in the fridge (pic. 10). If
you used all the milk during the coffee making, it is
recommended to remove and wash the cappuccinator
(see the chapter «CAPPUCCINATOR CLEANING»).