BRAYER BR1104, Instruction Manual

Page: 6 / 56

6 EN
is detected, and after it was dropped, unplug the unit
and apply to the service center.
• Transport the coffee maker in the original package.
• Keep the unit out of reach of children and disabled
• persons.
COFFEE MAKER IS INTENDED FOR HOUSEHOLD
USE ONLY, DO NOT USE THE COFFEE MAKER FOR
COMMERCIAL OR LABORATORY PURPOSES.
BEFORE USING THE COFFEE MAKER
After unit transportation or storage at low
temperature, it is necessary to keep it for at least
three hours at room temperature.
• Unpack the coffee maker and remove all the
packaging materials.
• Keep the original package.
• Check the delivery set.
• Read the safety measures and operating
recommendations.
• Examine the coffee maker for damages, in case of
damage do not plug it into the mains.
• Make sure that the specifications of power supply
voltage specified on the lower panel of the unit
correspond to the specifications of your mains. When
the unit is used in the mains with 60 Hz frequency, it
does not need any additional settings.
• Wipe the surface of the coffee maker body with a
clean, slightly damp cloth to remove dust.
• Make sure that all the control buttons (10, 11, 12) are
in the off position.
• Make sure that the steam supply is closed. To do this
turn the knob (15) « » clockwise until bumping
«•».
• Before using the coffee maker for the first time, wash
all removable parts (5, 6, 17, 20, 21) with warm water
and dry them.
• Before switching the unit on, make sure that voltage
of the mains corresponds
• to unit operating voltage specified on the unit body.
When the unit is used in the mains with 60 Hz
frequency, it does not need any additional settings.
• Remove the water tank (20), fill it with cold water up
to the MAX mark and install it back to its place.
• Notes:
- to fill the water tank (20) with water you can lift the
lid (19), fold it back and pour water into the tank
(20).
- do not use the lid (19) to carry the water tank (20).
• Install the coffee filter (6) into the holder (5) having
preliminary matched the ledge on the filter (6) with
the groove on the holder (5) and turn the filter (6)
counter/clockwise to fix the filter.
• Install the filter holder (5) into the coffee maker. The
holder (5) ledges should match the grooves on the
boiler « », after that turn the filter holder handle
(4) to the right until bumping « ».
• Place a suitable cup on the grid (2).