BRAYER BR1104, Instruction Manual

Page: 10 / 56

10 EN
(15) « » counterclockwise to release some
steam. After that close the steam supply by turning
the knob (15) « » clockwise until bumping
«•». Switch the steam supply off by pressing the
steam supply button (10) « » and switch the
coffee maker off.
• Wait until the coffee maker cools down and remove
the tip (17) from the cappuccinator pipe (16), wipe
the outer side of the cappuccinator pipe (16) with a
soft damp cloth and wash the tip (11) under a water
jet.
• Note: Successive making of coffee should be
performed with an at least 5 min interval.
WARMING THE DRINKS
• You can warm up your drinks by putting the
cappuccinator pipe (16) without the tip (17) into the
cup with the drink.
• Press the steam supply button (10) « », wait until
the indicator (9) « » lights up.
• Put the cappuccinator pipe (16) without the tip (17)
into the cup with the drink
• you want to warm up. Carefully turn the steam supply
control knob (15) « » counterclockwise.
• Close the steam supply by turning the knob (15) «
» clockwise until bumping «•».
• Switch the steam supply off by pressing the steam
supply button (10) « » again.
• Switch the coffee maker off by pressing the on/off
button (11) « », the indicator (7) « » will go out.
• Note: some water or steam may appear from the
filter holder (5), it is normal.
REMOVING MINERAL SCALE
For effective operation of the coffee maker we
recommend removing scale every 2-3 months and when
using “hard” water more often.
1. Make sure that all the control buttons (10, 11, 12)
are in the off position.
2. Make sure that the steam supply is closed. To do
this turn the knob (15) « » clockwise until
bumping «•».
3. Make citric acid solution: 2 teaspoons of acid to 1
litre of water and pour the solution into the water
tank (20). Install the tank (20) back to its place.
4. Install the coffee filter (6) into the holder (5) having
preliminary matched the ledge on the filter (6) with
the groove on the holder (5) and turn the filter (6)
counter/clockwise to fix the filter. Do not put ground
coffee into the filter (6).
5. Install the filter holder (5) into the coffee maker. The
holder (5) ledges should match the grooves on the
boiler « », after that turn the filter holder handle
(4) to the right until bumping « ».
6. Place a suitable cup on the grid (2).
7. Insert the power plug into the mains socket.
8. Switch the coffee maker on by pressing the on/
off button (10) « », the indicator (7) « » will
light up.