Brave VH1322GC, Owner/Operator And Safety Manual

Page: 12 / 48

Assembly Instructions
Brave
10
800-350-8739
Assembly Procedure
CAUTION
Some components are very heavy and can be damaged if mishandled. To
help prevent personal injury, it is strongly recommended that two (2)
people work together to uncrate and assemble the log splitter.
1
. Remove and read all instructions and safety recommendations before assembling or
operating this log splitter.
CAUTION
The rail assembly is bolted to the pallet with a lag screw. The rail is top heavy
and can tip over when it is unbolted, which could cause personal injury. Make
sure the pallet is on a flat, level surface before removing the bolt.
2 . Cut the bands holding the base unit and
rail assembly onto the pallet. Before
removing the base unit from the pallet,
install the front leg assembly. Align the top
rear hole in front leg with the rear top hole
in the base unit and install a 1/2-13 x 4-1/2
inch long hex head bolt through the holes.
Install and tighten the locknut.
NOTE: To prevent the front leg from
binding, do not over tighten the locknut.
3 . Place the front leg in the 45 degree down
position and install the hitch pin through
the lower front hole of the base unit and
front leg.
4 . Install the hair pin clip through the hitch
pin.