Brave VH1322GC, Owner/Operator And Safety Manual

Page: 16 / 48

Assembly Instructions
Brave
14
800-350-8739
17
. Attach high-pressure hose (A) to the
bottom valve fitting.
NOTE:
The high-pressure hose is self-
sealing and does not require any type of
sealing material. Tighten the fitting with
the 10 inch crescent wrench.
18 . Attach the end of low-pressure return
hose (B) to the fitting on top of the valve.
Position and tighten the hose clamp
approximately 3/8 inch from the end of the
hose.
NOTE: Steps 19 and 20 apply to
installation of fenders on model VH1326
only.
19 . Install the left and right-hand fender
brackets using two 5/16-18 x 3/4 inch long
hex head bolts and locknuts for each
bracket. Install the bracket with the
slotted holes against the base unit (round
holes up).
NOTE: The right-hand side of the log
splitter is the right side when viewed from
the hitch end.
20 . Bolt the fenders onto the fender brackets
using two 5/16-18 x 3/4 inch long hex
head bolts and locknuts. The fenders are
interchangeable (left or right). Position
the fender with the bolts in the middle and
front holes. This should place the fender
over the tire with equal spacing in the
front and back.