Braun 06 Series L915, Operator'S Manual

Page: 19 / 45

Page 17
Pre-L i f t Oper ati o n No t es an d D e tai ls
WARNING
Discontinue lift use
immediately if any lift
component does not
operate properly.
Failure to do so may
result in serious
bodily injury and/or
property damage.
Folding the platform fully first will
ensure that the Lift-Tite
™ latches
will disengage properly when
the release valve is opened (in
event of platform drift). Manual
Operating Instructions are
provided on pages 32-34.
Bridge Plates and Inboard
Roll Stops:
L915 Series lift
models are available with an
automatic inboard roll stop that
also serves as the bridge plate
(“
IB ” lift models), or a combina-
tion stationary inboard roll stop
and an independent hinged
bridge plate (“
non-IB ” lift
models). An “ IB ” lift model is
depicted in the Lift Terminology
Illustration on page 7.
Automatic Inboard Roll Stop
and Bridge Plate:
L915 “ IB ” lift
models are equipped with an
automatic inboard roll stop that
also serves as the bridge plate
(automatic inboard roll stop
photos on page 18).
When the UNFOLD switch is
pressed and the platform unfolds
from stow position to floor level,
this mechanical roll stop/bridge
plate is automatically deployed to
the bridging (horizontal) position
to provide a bridge plate between
the platform and the lift base plate
(vehicle floor). The inboard edge
of the bridge plate rests on the lift
base plate.
The mechanical roll stop/bridge
plate automatically folds (rotates)
to the vertical (roll stop) position
when the platform lowers to the
ground (DOWN switch is
pressed).
As the UP switch is pressed and
the platform raises from ground
level, the roll stop automatically
unfolds (rotates) to the horizontal