18
C
C
2 / INSTALLING YOUR DISHWASHER
EN
• DRAINING AWAY THE WASTE WATER: FIG. 2
You can connect the end of the drain hose to:
- A ventilated U-bend or
- A sink U-bend
When connecting to a U-bend, you must remove
the flapper from the U-bend. Then fully install the
rubber end. If necessary, add a tightening collar
.
NB:
Ensure that the drain hose is held in
place with a tie to avoid any potential flooding.
The drain connection must be 0.40m (minimum)
to 0.90m (maximum) above the floor.
Make sure that you adhere to the maximum
dimensions for the fitting of the drainage tube in
the siphon pipe
P10
If necessary, you can increase the hose’s
length (up to 3m maximum). In this case,
check that the appliance drains correctly.
The hose must rest on the floor and only
rise vertically close to the drainage system.
For appliances installed in vertical units,
the drainage system must not rise higher
than the top of the appliance.
Important:
When fitting the hose, pull on it gra-
dually so as not to kink it.
.
Avoid any kinks or constrictions in the
hose, which could prevent the water from
passing or slow down its flow.
B
15 cm
maxi
0 - 40 cm
20 cm mini
5 cm
mini
25 cm
mini
90 cm maxi
+
65°C max
1-10 bars
> 1l/min
Fig. 2
