Cleaning
20
Anomalies and solutions
ANOMALIES AND SOLUTIONS
The oven is not heating.
Check that the oven
is correctly connected and that your installation’s
fuse is not out of service. Increase the selected
temperature.
The oven light is not working.
Replace the
bulb or the fuse. Check that the oven is correctly
connected.
The cooling fan continues to operate after
the oven stops.
This is normal; the fan may
continue running until a maximum of 1 hour
after cooking to lower the temperature inside and
outside the oven. If the fan runs for over an hour,
contact the After Sales Department.
The pyrolysis cleaning cycle does not begin.
Check that the door is locked. If there is a door
locking or temperature sensor fault, contact the
Customer Services Department.
The symbol
flashes in the display.
Door locking fault; contact the Customer Services
Department.
Vibration noise.
Check that the power cord is not in contact with
the rear wall.
This does not affect the proper operation of your
unit, but may generate vibration noise during ven-
tilation. Remove your unit and move the cord. Re-
place your oven.
Service Calls
