INSTALLATION INSTRUCTIONS
16-pin Connector face
NOTE: If vehicle is not equipped with a power mirror
use this wire for reverse
.
In the factory wire harness located in the passenger foot
well, locate the White/Gray Reverse signal wire and
splice Green Reverse wire from supplied Mirror Harness
11.
Connect supplied Mirror connector to supplied Mirror
Harness.
12. Connect the male RCA from the supplied chassis
harness to the female RCA on the supplied mirror
harness
13. Test the system. Start vehicle and shift into Reverse
in order to check that all connections were made
properly. If all of the connections are correct you will
see the camera image displayed on the display
mirror
14. Reassemble vehicle. Follow your disassembly steps
in reverse order, taking care not to bind the harness
wiring when reinstalling the trim.
9002-8846 Instructions 9-17-19
Page 8 of 8
DM
