INSTALLATION INSTRUCTIONS
25.
Using a plastic trim removal tool, remove HVAC
panel.
26. Connecting Power
Splice Red power wire at the RCA to red 12v+ wire
on mirror harness OR splice red wire at chassis
harness connector to 12v+ in the back of the
vehicle. COVER UNUSED RED WIRE. Splice Black
Ground at rear to chassis ground. RECOMMENDED:
Use solder and cover with heat shrink tubing or use
T-taps as an alternate connection method.
Mirror Installation
1.
Unplug factory mirror connector from back of mirror.
2.
Use a T15 Torx bit to remove factory mirror and
slide the mirror upward off the mounting tab.
CAUTION: Do not twist mirror as windshield damage
could result.
3.
Carefully install supplied Mirror by sliding it
downward on the mounting tab. CAUTION: Torque
supplied Mirror screw to 1.8 Nm (16 lb-in) and do
not exceed 2.2 Nm (19.5 lb-in).
4.
Begin running 10-pin mirror connector end of Mirror
Harness to mirror by first removing IP access panel.
9002-8846 Instructions 9-17-19
Page 6 of 8
DM
