INSTALLATION INSTRUCTIONS
If the camera harness is run through the center on the camera
bracket, it will cut the camera harness. This will void the
warranty on the camera.
Camera Power Instructions!: Only ONE of the red wires should be connected to ignition 12v+.
The other should be isolated with electrical tape before powering camera up. See step 26.
Camera Installation
1.
Loosen lug nuts to remove the spare tire.
2.
Slide Camera on studs placing harness end inside of
tire carrier.
Do not run harness through the
camera bracket opening
.
3.
Temporarily replace spare tire to check wheel
clearance to Camera. Adjust camera head to fit your
specific wheel. Bracket is shipped in factory wheel
configuration
Adjustment Bracket for Camera Clearance using Phillips
Screwdriver and 3/8” Wrench or Socket Drive
Note:
Short Bracket has been designed for Factory offset
9002-8846 Instructions 9-17-19
Page 2 of 8
DM
