Brady Bradyprinter 200MVP, User Manual

Page: 40 / 110

30 Bradyprinter 200MVP and 300MVP User’s Guide
3RZHU5HZLQG0RGH
(Power rewind option required)
Refer to Figure 20.
1. Press the printhead open lever. The printhead assembly springs up.
2. Place the roll of media on the media supply spindle and push the roll back as far as
it will go.
3. Feed the media under the dancer, through the slot in the adjustable transmissive
sensor, and under the ribbon sensor.
4. Pull approximately 36" (915 mm) of media through the front of the printer.
5. Ensure that the media is against the back of the adjustable transmissive sensor.
Then, slide in the media guide so that it just touches, but does not restrict, the edge
of the media.
6. Remove at least 12" (305 mm) of labels from the backing material.
7. Feed the backing material over the front housing assembly, through the rewind
base, and under the media alignment spindle.
8. Loosen the thumbscrew and slide out the rewind media guide to the end of the
take-up spindle.
9. Wrap the media around a core placed on the take-up spindle; then, turn the take-up
spindle counterclockwise to wind up the excess material.
10.Slide the rewind media guide against the media, and tighten the thumbscrew to
lock it into position.
11. Close the printhead assembly.
All manuals and user guides at all-guides.com