Brady Bradyprinter 200MVP, User Manual

Page: 36 / 110

26 Bradyprinter 200MVP and 300MVP User’s Guide
/LQHU7DNHXS0RGH
(Liner take-up option required)
Refer to Figure 18.
1. Press the printhead open lever. The printhead assembly springs up.
2. Place the roll of media on the media supply spindle and push the roll back as far as
it will go.
3. Feed the media under the dancer, through the slot in the adjustable transmissive
sensor, and under the ribbon sensor.
4. Pull approximately 18" (500 mm) of media through the front of the printer.
5. Remove the labels from the 18" of media so that only the liner remains.
6. Ensure that the media is against the back of the adjustable transmissive sensor.
Then, slide in the media guide so that it just touches, but does not restrict, the edge
of the media.
7. Pull down the lever to open the pivot bracket assembly, on the peel assembly.
8. Feed the media over the tear-off/peel-off bar and behind the pivot bracket
assembly.
9. Close the printhead assembly.
10.Close the pivot bracket assembly.
11. Slide the liner into the slot in the spindle (as
shown). Make sure the liner is resting against
the back plate of the spindle assembly.
12.Turn the spindle assembly counterclockwise a
few times so that the liner is snug.
Peeling starts automatically. Press the FEED key to test.
All manuals and user guides at all-guides.com
all-guides.com