Brady Bradyprinter 200MVP, User Manual

Page: 38 / 110

28 Bradyprinter 200MVP and 300MVP User’s Guide
3RZHU3HHORII0RGH
(Power peel-off option required)
Refer to Figure 19.
1. Press the printhead open lever. The printhead assembly springs up.
2. Place the roll of media on the media supply spindle and push the roll back as far as
it will go.
3. Feed the media under the dancer, through the slot in the adjustable transmissive
sensor, and under the ribbon sensor.
4. Pull approximately 36" (915 mm) of media through the front of the printer.
5. Ensure that the media is against the back of the adjustable transmissive sensor.
Then, slide in the media guide so that it just touches, but does not restrict, the edge
of the media.
6. Open the front housing assembly by lifting the handles; then, pivot down the front
housing assembly.
7. Remove at least 12" (305 mm) of labels from the backing material.
8. Feed the backing material over the tear-off/peel-off bar, through the rectangular
cutout in the mounting bracket, and under the media alignment spindle.
9. Close the front housing assembly by slightly lifting and then hooking it onto the
pins on the tear-off/peel-off bar.
10.Loosen the thumbscrew and slide out the rewind media guide to the end of the
take-up spindle.
11. Wrap the backing around a core placed on the take-up spindle; then, turn the
take-up spindle counterclockwise to wind up the excess backing material.
12.Slide the rewind media guide against the backing material and tighten the
thumbscrew to lock it into position.
13.Close the front housing assembly.
14.Close the printhead assembly.
All manuals and user guides at all-guides.com