Installation
WBD1
Bradley
• 215-1890 Rev. E: ECO 20-08-028A
10/29/2020
13
Attach Soap Motor and Soap Container Bracket
3
Reference LVA Series and LD-3010 Series installation manuals
for instructions on bracket assembly, drain assembly, P-trap
assembly, and access panel assembly.
The liquid soap pump has a rubber sleeve
that fits over the soap container opening.
The foam soap pump has an interior white
cylinder that fits into the soap container.
The fit may be tight. Move the gallon soap
container laterally while applying pressure
to seat them together approximately
1/4" (6 mm) into soap container opening.
Attach soap motor control box and soap
container bracket to wall using #10 screws
at the locations shown in the Structural
Rough-In drawing.
A
Attach soap syphon tube to the bottom
of the soap pump.
Install soap pump into the soap control box.
Clear soap bracket and hold in place
against the wall.
Secure soap pump to the soap control box
using the small hook and loop strap.
Slide the gallon soap container over
the soap syphon tube, and push the
soap container up into the soap pump
approximately 1/4" (6 mm).
B
C
F
D
E
Soap
Container
Bracket
Gallon
Soap
Container
Soap Syphon
Tube
Soap Pump
(Liquid or Foam)
Attach soap
supply tube
here.
Ensure soap pump flange
is positioned below control
lever box.
Slide soap container bracket up until
it touches the bottom of gallon soap
container. Tighten the #10 screws to secure
the soap container bracket to the wall.
Remove the gallon soap container by
swinging it away from the wall and lowering
it from the soap syphon tube (see below).
Store soap container for later installation.
G
H
Liquid soap pump
shown. Foam soap
pump similar.
Small Hook &
Loop Strap
Soap Motor
Control Box
Alternate location
for adding a small
hook & hoop strap
to an older soap
pump assembly