WBD1
Installation
18
10/29/2020
Bradley
• 215-1890 Rev. E: ECO 20-08-028A
Master Control Box
Scan to watch maintenance and
troubleshooting videos for the WashBar!
6V Power LED
Over Current LED
LCD
Status LED
USB Connector
Soap Cable
Water Valve Cable
(Female)
Proximity Cable (USB
1.1 Mini B, Female)
LED Board
Connector
Sensor Board 2
Connector
Sensor Board 1
Connector
12V 2A
Barrel Plug
System Startup
The first time the WashBar is powered up, there is a sequence of LEDs that will light up.
• Within 5-10 seconds of receiving power, the WashBar will cycle it's LED lights RED, GREEN and then BLUE. Once
the LEDs turn blue, the WashBar is in Standby/Idle Mode.
Before providing power to WashBar, make sure the area under the WashBar is clear of any obstructions and that sensors
are clear.
• The power LED on the master control box will be GREEN indicating the unit has power.
The first time the WashBar is powered up, there is a series of items displayed on the LCD screen.
• Control software revisions (ex. "000")
• Control software type ("2-1" is for a system with no dryer, "3-1" is for a system with a dryer).
If any of the WashBar LEDs flash RED, check for sensor obstruction. Once obstruction is removed or cleaned, the
WashBar LEDs will return to blue indicating that the WashBar is in Standby/Idle Mode.
The control box can be configured for either system. See website for instructions on how to change system "FLAG" or
contact Bradley customer service.