MF2944/BIR3
Installation
8
6/6/2014
Bradley •
215-1373 Rev. P; ECN 14-00-006
6
Electrical and Supply Connections
Connections of leads other than shown may cause permanent damage to the sensor.
Sensor cables must be attached before the battery cables are plugged into the
circuit boards.
A
Insert 4 different colored sprayhead
supply tubes into four solenoid tube
connectors by loosening tube connector
cap and firmly pushing tubing into tube
connector until the tubes are fully seated,
then re-tighten connector cap .
B
Connect the sensor cable from the right
hand station to the circuit board attached
to the solenoid with the yellow supply
tube .
C
Connect the sensor cable from the
right center station to the circuit board
attached to the solenoid with the black
supply tube .
D
Connect the sensor cable from the left
center hand station to the circuit board
attached to the solenoid with the green
supply .
F
Insert the batteries into the battery
holders and then mount the battery
holders (with batteries) in a convenient
location in the pedestal .
G
Snap the battery connector cables into
the circuit board plugs .
Black Supply Tube
(from Sprayhead)
Green Supply Tube
(From Sprayhead)
Red Supply Tube
(From Sprayhead)
Solenoid
Connector
Compression
Nut
Solenoid Assembly
Navigator Mixing
Valve
Supply Inlet
Battery Cable
Sensor Cable
Battery Holder (S83-177)
6-Volt Lithium Battery
Type DL223A or Equivalent
(261-010)
E
Connect the sensor cable from the left
hand station to the circuit board attached
to the solenoid with the red supply .
Yellow Supply Tube
(from Sprayhead)
