IMPORTANT INFORMATION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
MVM Instructions |
Page 1
IMPORTANT INFORMATION
Please read instructions completely before installing this Bracketron MVM Mount. All instructions are written from the drivers seat van-
tage point looking forward at the vehicles dash. We advise caution whenever you are removing or handling plastic parts of a vehicles
dash.
WARNING:
Unnecessary force or pressure can cause pieces to crack or break.
PARTS INCLUDED: MVM-45-05 Mount, 3 - #8x3/4” Self Tapping Screws, 2 - M4x8 Phillips Pan Head Screws, 2 - M4 Nylon Stop
Nuts, PHS-203 Ultra Slim Swivel and Mounting Hardware.
TOOLS NEEDED FOR MVM MODIFICATION (
if required
)
4 inch Mounted Bench Vise
12 oz. Ball Pein Hammer
Standard Tin Snips
Standard Hacksaw
Small File
TOOLS NEEDED FOR DASH PANEL DISASSEMBLY
Dash Trim Tool (Part #SIT-104)
# 2 Phillips Screwdriver
T-20 Torx bit and Driver
9/32” Open End Wrench (for swivel)
Marking Pen
DASH DISASSEMBLY INSTRUCTION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Start by removing the three (3) T-20 Torx screws toward the bottom of
the glove box. Open the glove box and locate and remove three (3) more
screws toward the top. Set the screws aside. Insert the Dash Trin tool (part
#SIT-104) in between the radio bezel where it meets the dash molding on
the right side releasing two (2) clips. Open the molding up enough to get
to the exposed T-20 Torx screw.
Skip to Step 6 on the following page if you have not yet formed the
bracket to fit your vehicle.
Remove the exposed T-20 Torx screw. Place the MVM over the hole and
replace the T-20 Torx screw. Tighten down the MVM.
Carefully reinstall the dash in reverse order securing all screws and clips
to the bezel. Attach the face of the MVM to the section that is protrud-
ing out from the dash. Align the holes and attach the two pieces with the
provided M4x8 Phillips Pan Head Screws and M4 nylon Locking Nuts.
Use the #2 Screwdriver and 9/32” open end wrench to tighten.
Install the included Ultra Slim Swivel #PHS-203 to your Multi Vehicle
Mount or any other AMPs compatible device.
Your installation is complete
Install Mount Here
1
2
3
5
4
Note:
The hole pattern on the face of the MVM maybe
different then what is shown in the pictures.
