BOXLIGHT ProjectoWrite6, User Manual

Page: 13 / 98

11
Setting Up
WARNING
● Do not touch around the lamp cover and the
exhaust vents during use or just after use, since it is
too hot.
● An apparatus with CLASS I construction shall
be connected to a MAINS socket outlet with a
protective earthing connection.
● The MAINS plug or an appliance coupler shall
remain readily operable.
WARNING
● A strong light is emitted when the projector’s power
is on. Do not look into the lens of the projector
or look inside of the projector through any of the
projector’s openings.
CAUTION
● Do not turn off the AC power for 60 seconds
after the lamp is turned on. Doing so could cause
premature lamp failure.
Power ON / OFF
AC inlet
Outlet
Focus ring
1.
2.
3.~4.
5.
Turning On The Power
1. Make sure that power cord is firmly and
correctly connected to the projector.
2. The green Power indicator blinks slowly.
3. Remove the lens cover.
4. Press POWER button on the Touch Keypad
or the remote control to turn on the projector.
5. Rotate the focus ring to adjust the focus.
Turning Off The Power
1. Press the POWER button on the Touch
Keypad or the remote control. The "power
off" confirmation message will appear.
2. Press the POWER button again while the
message is shown on the screen.
3. When the projector enters "Standby" mode,
the green Power indicator blinks slowly.
4. The projector cannot be turned on while red
"Lamp indicator" is blinking slowly in cooling
mode.
5. If you don’t use the projector for a long time,
remove power cord.