Shenzhen Bowei tech Co.ltd.
ADD:RM902;ShangMei Times;NO.57;LongGuan RD;Long Hua Dist Shenzhen, China;518000
Tel:86-755-29994192 13148703639
Email:[email protected] http://www.bowei-ch.com/
After turning on the power supply, please observe the water circulation
inside the device.Normally, you will hear the sound of water flow. About
3-5 minutes later, the probe runs
cold, at this time, it’s able to insert the
relevant crystal and start to operation
If the water doesn‟t cycle inside the device, or the probe does not cold, it‟s possible that
there is air in the pump. At this moment, please turn on the device, when turn to the
welcome screen( do not do any operation on the screen at the moment), then fold the
white hose( in handle) to the angle of 90 degrees and slack, then turn off the device;
repeat this action for 3-6 times. That could exhaust the air to the water tank, then the air
will exhaust from the orifice for spilt water and the orifice for input water (of course, at this
moment, should screw off the screw caps of the orifice for spilt water and input water at
the same time)
PARAMETERS INTRODUCTION
