20
5. Using a 6 mm hex wrench, remove the indicated bolt from the Flywheel and
remove it.
Note:
Push down and hold the Walking Belt still when removing the bolt. Be sure
to observe the Speed Sensor Magnet orientation on the Flywheel Assembly for
re-assembly.
6. Disconnect the Speed Sensor Cable from the Speed Sensor.
7. Using a 16 mm wrench, loosen the Belt Tensioner Bolt until the Drive Belt is
slack.
Note:
Count the visible Belt Tensioner Bolt threads before loosening to assist with
reassembly.
8. Turn the Drive Pulley clockwise while forcing the Drive Belt to the outside. Belt
will come off of the Drive Pulley and Rear Roller Pulley.
Keep fingers out of any pinch opportunities when turning the Pulleys.
Note:
Chain guard is not shown in images.
Speed Sensor
Back of Speed Sensor
Magnet
Right Roller
Bearing Plate
Right Roller
Bearing Plate
Speed Sensor
Speed Sensor Cable
(disconnected)
Drive Pulley
Belt Tensioner Bolt
Rear Roller
Pulley
