Bowflex LateralX LX3, Service Manual

Page: 10 / 54

10
The Machine Settings Mode lets you view the total run hours for the machine and the current versions of the main systems.
1. Hold down the STOP/PAUSE button and Right arrow button together for 3 seconds while in the Power-Up Mode to access the Machine Settings
Mode.
Note: Push STOP/PAUSE to exit the Machine Settings Mode and return to the Power-Up Mode screen.
2. The Console displays the TOTAL HOURS for the machine.
3. Push the Right button to go to the next option.
4. The Console display shows the current Console Firmware Version.
5. Push the Right button to go to the next option.
6. The Console display shows the current Motor Control Board Firmware Version.
7. Push the Right button to go to the next option.
8. The Console display shows the current BLE Version.
9. Push the Right button to go to the next option.
10. The Console displays the DISCONNECT BLE NO prompt.
Note: If you want to disconnect the Bluetooth
®
transmitter, push the Increase/Decrease buttons to select the “DISCONNECT BLE YES”
option, and push Enter. The Console will exit the Machine Settings Mode and return to the Power-Up Mode screen.
11. Push the Right button to go to the next option.
12. The Console displays the VIEW ERROR MSG NO option. This option is for Service Technicians use only.
13. Push the Right button to go to the next option.
14. The Console displays the RESET CONSOLE NO prompt.
Note: If you want to reset the Console to factory settings, push the Increase/Decrease buttons to select the “RESET CONSOLE YES”
option, and push ENTER. Turn the machine off when the Console displays the “POWER CYCLE NOW” prompt.
15. Push the STOP/PAUSE button to exit the Machine Settings Mode and return to the Power-Up Mode screen.
MACHINE SETTINGS MODE
Replacement Procedure Skill Level
Level I : Low - very little mechanical knowledge or exposure.
Level II : Intermediate - some experience with mechanical procedures.
Level III : Advanced - knowledgeable about mechanical procedures.
!
Disconnect all power to the machine before you service it.
When disposing of old parts, obey the applicable local and provincial requirements.
For instructions to replace the following parts, please refer to the Assembly Manual for your machine:
• Power Cord