Bourgeat 870801, Instructions For Use And Maintenance Manual

Page: 5 / 20

5
RANGE
y
870904 : Hotplate 600x400mm.
870906 : Hotplate 600x600mm.
870801 : GN1/1 extra-low hob.
870804 : 600 x 400 extra-low hob.
y
Enables temperature to be maintained at above 63°C for buffets, service, plate loading.
Ideal for : plates, GN1/1 gastro standard trays and sub-sizes to a maximum height of 40mm, pastry trays, serving dishes.
y
They are not to be used to reheat or cook.
SPECIFICATION
Models 870904 870906 870801 870804
L x l x H mm 600 x 400 x 90 600 x 600 x 90 530 x 325 x 38 600 x 400 x 40
Net weight 12 kg 18 kg 2 kg 2 kg
Maximum load 10 kg 10 kg 10 kg 10 kg
Voltage 230 V single phase 50/60 Hz
Power 500 W 750 W 225 W 330 W
Amperage 2,5 A 3,5 A 1 A 1,5 A
IP (Protection index) 21 21 21 21
EU approved. These hotplates are conform with NF EN60335-1, NF EN60335-2-12 and NF EN55014-1.
ELECTRICAL WIRING
y
Spiral flex provided with the device.
y
Tension 230V sigle phase 50/60 Hz
y
The device must be connected to a socket (single phase - 10/16 Amps+earth) and should be protect with a high sensitivity
fluctuation device.
y
Hotplates 870904 / 870906 : Before plugging or unplugging, make sure that the general luminous switch, locéated on the
front part of the control board is switched off.
y
Any interference with the wiring will void the guaranty.
USAGE
y
Hotplates 870904 / 870906:
-
Turn switch to “ 0 ".
-
Connect the plug (2 earth).
- Put switch in position 1 .
-
Adjust the thermostat (80°C minimum).
-
Preheat 20min before using your hotplate.
y
Extra-low hobs 870801 / 870804 :
- Plug 2P + G plug into socket.
-
Allow heating plate to warm up for 20 mn before using it.
PRECAUTIONS OF USE
y
The upper part of the hotplate can be very hot and can bring about some burns.
y
Extra-low hobs :
-
do not use knifes or cutting utensils on top of heating plates.
-
keep plate away from a flame or a heat source.
y
To disconnect the hot plate from the power supply, pull on the plug and not on the plate.
y
Do not carry the hot plate by the electrical cord.
y
Do not push the hot plate up against a wall. Leave sufficient distance so as not to bend the cord.
SERVICE
Hotplates 870904 / 870906 :
y
When the device switches on nothing lights :
-
Check the electrical wiring.
- Check switch is position 1 .
ENGLISH