Bounty Hunter Land Ranger, Owner'S Manual

Page: 22 / 48

19
TIP:
Initially, if the unit is not reacting properly, push the ALL
METAL SMART TRAC
touch pad a couple of times to make
sure that the batteries are connected and not discharged.
▲
To adjust sensitivity in ALL METAL mode
For maximum sensitivity, you should hear a slight threshold hum while
operating in ALL METAL mode. If you do not hear this threshold hum,
sensitivity is low and the audio level requires adjustment.
To adjust the audio level
1. Make sure that the arrow in the
GROUND MONITOR
dial points
to 0; sensitivity adjustments should only be made when the
GROUND MONITOR dial indicates that the detector is properly
ground balanced.
2. Press the ALL METAL AUDIO LEVEL - touch pad or the ALL
METAL AUDIO LEVEL +
to adjust the audio level.
The arrow on the
LEVEL
dial in the LCD display reflects your
adjustment, +/- and you should hear a slight threshold hum .
▲
To adjust detector when ground conditions change
If actual ground conditions change (example: moving from low to
highly mineralized ground, or vice versa) the SMART TRAC system
automatically makes the adjustment for the variation. You will hear
a momentary change in the threshold hum while the unit makes the
adjustment. Do not make any adjustments to the ALL METAL
AUDIO LEVEL at this time; simply wait about 10 seconds and the
hum will return to normal.
If the hum does not return to normal after 10 seconds
1. Press
ALL METAL SMART TRAC
for an instant ground balance
update.
2. If the hum does not return to normal after pressing ALL METAL
SMART TRAC, lower the unit’s threshold using the ALL METAL
AUDIO LEVEL +/- touch pads.
If you are getting a constant signal
1. Try moving the search coil to a different location and press ALL
METAL SMART TRAC for instant ground balancing (in case
metal is setting the unit off).
2. If you are still getting a constant signal, lower the unit’s threshold
using the ALL METAL AUDIO LEVEL +/- touch pads.