GENERAL: F2 33
Enhanced:
[On, Off]
Normally, the terminal responds to a set of commands that correspond to the
emulation selected. When Enhanced mode is
on
, the set of commands is extended to
those printed in boldface in the Programming chapter.
EIA Data Format: [
7/1/N, 7/1/O, 7/1/E, 7/1/M, 7/1/S, 7/2/N, 7/2/O, 7/2/E,
7/2/M, 7/2/S, 8/1/N, 8/1/O, 8/1/E, 8/1/M, 8/1/S, 8/2/N, 8/2/O, 8/2/E, 8/2/M,
8/2/S]
Select a data bits/stop bits/parity combination which matches the data format of the
primary host or printer. Parity abbreviations are: O = odd, E = even, S = space, M =
mark, and N = none.
AUX Data Format:
[7/1/O, 7/1/E, 7/1/M, 7/1/S, 7/2/N, 7/2/O, 7/2/E, 7/2/M,
7/2/S, 8/1/N, 8/1/O, 8/1/E, 8/1/M, 8/1/S, 8/2/N]
Select a data bits/parity bits/stop combination which matches the data format of the
secondary host or printer. Parity abbreviations are: O = odd, E = even, S = space, M
= mark, and N = none.
Language: [U
.S., U.K., Danish, Finnish, French, German, Norwegian,
Portuguese, Spanish, Brazilian, Swedish, Dutch, Belgian-Flemish, Fr-Canadian,
Italian, Latin American, Swiss-French, Swiss-German, Turkish, Greek, Hungarian,
Czech, Slovak, Polish, Rumanian, Slovenian, Croatian, Bosnian, Serbian Latin,
Russian, Hebrew]
Select the language type which matches your keyboard’s layout.
Language:
[U.S., U.K., Danish, Dutch, Finnish, Belgian-Flemish, French,
Fr-Canadian, German, Italian, Norwegian, Spanish, Swedish, Swiss-German
Swiss-French, Turkish]
Select the language type which matches your keyboard’s layout.
Sessions:
[One, Two]
Select the number of sessions that the terminal will run. One session is required per
connection to a host. When two sessions are selected, the Setup menu will display the
message “Press
Ctrl-Enter (Kpd)
to Toggle Sessions” at the bottom of the screen. The
current session is displayed at the upper left corner of the status line (either by a SES1
or SES2 indicator). To change the active session, p ress
Ctrl
and
Enter
(on the numeric
keypad) simultaneously.
Host/Printer:
[EIA/Aux, EIA
/
Para, EIA/None, Aux/EIA, Aux/Para, Aux/None,
None/EIA, None/Aux, None/Para, None/None]
The first part of the selection indicates the host (either the EIA port or the AUX port)
and the second part of the selection indicates the printer port (if a serial printer is used,
either the EIA or Aux port can be used to connect to the printer, but if a parallel
printer is being used, the PAR port should be used.) The active session “drives” the
printer. EIA/Para is the default for session 1, and Aux/None is the default for session
2.
GENERAL: F2
This chapter lists all possible parameters for each menu, and all possible choices for
each parameter. Depending on the emulation selected, and the key mode (ASCII or
ScanCode), Setup will only present the valid set of parameters and choices in each
menu.
