Boston Whaler 330 Outrage 2023, Owner'S Manual

Page: 82 / 189

3-7
Section 3 • Systems Overview & Operation
330 Outrage
R
OFF
ON
C
B A
O
T
M
T
B
E
I
R
N I
E
ES
OFF
ON
UNSWITCHED SWITCHED WINDLASS
ENGINES HOUSE
ACR
AUTOMATIC CHARGING RELAY
BLUE SEA SYSTEMS - 7610
DUAL SENSING
LIGHT STATUS CHART
ON - COMBINED
OFF - ISOLATED
FAST FLASH - ISOLATED
UNDER VOLTAGE
LOCKOUT
ONE OR BOTH BATT
ARE BELOW 9.5V
Starting/Stopping the Engines
• Operator should know boating safety, safe
navigation, and boat operating procedures.
• Make sure that the lower unit of the engine is
in the water.
• Make certain the gear shift/throttle control is
in the neutral position. (The engine will not
start if the control lever is in any other position
than NEUTRAL)
• Be sure the engine emergency stop switch is
in the “RUN”position.
Starting the Engines
The port and starboard master ignition key switches
are located on the battery switch panel (Figure
3.7.1) behind an access door on the starboard gunnel
opposite the helm seat. The switches must be turned
on to activate the system.
NOTE: The engines cannot be started from this
location.
• Turn the master key
switches on (clockwise).
• Be sure gear shift/
throttle control levers
are in the NEUTRAL
position.
!
CAUTION
NEVER start or operate your outboard (even
momentarily) without water circulating
through all the cooling water intake holes in the
gearcase to prevent damage to the water pump
(running dry) or overheating of the engine.
Prior to Starting
NOTICE
The gear shift/throttle control levers will not
allow engine starting if the control levers are
in any other position than NEUTRAL.
• Press START/STOP
button(s).
The neutral “N” lights located
on the console controller will
become illuminated once
the engines are started and
communicating with the
remote controller.
PORT
STBD
N
N
SYNC
TRANSFER
1 LEVER
THROTTLE
ONLY
DOCK
Master Key Switches
Fig. 3.7.1
1
2
BATTERY SWITCH PANEL
MASTER KEY SWITCHES
PORT STBD
START
STOP
START
STOP
Warming Up the Engines
The “THROTTLE ONLY” button on the face of
the controller allows the operator to increase engine
RPM for warm-up without shifting the engines into
gear.
• Be sure that the gear
shift/ throttle control
levers are in the
NEUTRAL position.
2
1