Boston Whaler 330 Outrage 2023, Owner'S Manual

Page: 100 / 189

3-25
Section 3 • Systems Overview & Operation
330 Outrage
R
!
CAUTION
If equipped, the
Active trim panel
is located on the
forward hardtop
above the console.
A c t i v e T r i m
provides the benefit of perfect trimming without
constantly monitoring and adjusting trim with
changes to boat speed or when going into turns.
Active Trim controls the trim in accordance with
boat speed and engine rpm. This avoids potential
problems such as engines trimming up (instead of
down) if the propeller breaks loose in a hard turn. It
also avoids issues with the engine trimming up too
early or too late when the boat is getting on plane.
Active Trim has five selectable trim profiles that
accommodate nearly any boat application. These
profiles allow operators to compensate for changes
in boat load, operator preference and weather
conditions, while maintaining full auto operation.
Active Trim (Option)
ON
RESUME
1
2
3
4
5
PROFILE
OFF
REFER TO THE MANUFACTURER’S MANUAL
IN YOUR OWNER’S MANUAL PACKET FOR
COMPLETE INSTRUCTIONS AND WARRANTY.
Shore Power
The 120V/30A shore power system provides
dockside power to operate all of your boat’s electrical
system and charge your batteries.
Use the supplied 50 ft. power cord to connect your
boat to a dockside power source. The boatside
receptacle is located under the aft starboard gunwale.
The main breaker panel for the shore power system
is located on the aft wall port side in the forward
console.
Shore Power Hookup
Before making shore power connections make sure
your boat is properly moored.
• Connect the female connector to the boat
receptacle first.
• Next connect the male connector to the
dockside panel.
• Check the breaker panel. DO NOT continue
if the “REVERSE POLARITY light is on.
Remove cordset and report the situation to
the dockmaster.
• If the reverse polarity light is not on, switch
the “SHORE POWER MAIN” on.
In addition to supplying alternative power to your
boat, shore power hookup gives you the ability to
charge your batteries without running the engines.
Shore Power Receptacle
Fig. 3.25.1
SHORE POWER INTERMEDIATE BREAKER
ELCI (EQUIPMENT LEAKAGE CIRCUIT
INTERRUPTER)
SHORE POWER RECEPTACLE
120V/30A SHORE POWER CORDSET
1
2
3
1
2
3
4
4
To minimize shock hazard:
• Be certain that the shore power main
switch is turned OFF before connecting the
power cord cordset.
• Connect the cordset to the boat inlet first,
then to the shore inlet.
• NEVER alter the cordset connectors.