Boston Whaler 330 Outrage 2023, Owner'S Manual

Page: 103 / 189

3-28
330 Outrage
Section 3 • Systems Overview & Operation
R
Use the anchor windlass switch on the helm
when possible. Use care when operating the
anchor windlass with the hand-held remote.
!
DANGER
Operating The Windlass With Remote
The anchor windlass can be operated from the bow
with the use of the windlass remote which is stowed
in the bow locker.
• To r a i s e
t h e
anchor, press and
h o l d t h e “ U P ”
button of the
remote.
• To l o w e r t h e
anchor, press and
hold the “DOWN”
button on the
remote.
• Plug the power cable
into the power receptacle
on the aft wall of the
anchor locker
(Figure 3.27.1)
• Turn the forward portion
of the plug clockwise to
lock.
Anchor Windlass Remote
Fig. 3.28.1
Keep hands, feet, hair and loose clothing clear
of moving parts. Entanglement may cause se -
vere bodily injury (i.e. lose of fingers or toes).
!
WARNING
1
2
3
WINDLASS REMOTE CONTROL
“DOWN” BUTTON
“UP” BUTTON
1
UP
DO
WN
2
3
NOTICE
Before operating the windlass be sure that
the safety lanyard is removed from the anchor
chain and is clear of the rode as it plays out or
is retrieved.
UP
DO
WN
Manual Operation
There are two star sockets on the top of the windlass
used for manual deployment of the anchor. Inserting
the emergency handle into the center socket and
turning it counter-clockwise will loosen the anchor
windlass chainwheel. The star socket located off-
center is used for retrieving and lowering the anchor.
Turning the handle counterclockwise will allow you
to lower the anchor, while turning it clockwise will
raise it.
Operating The Windlass Manually
In the event that there is a loss of power to the
windlass the anchor can be raised and/or lowered
manually by using the emergency handle located in
the bow locker.
If there is a loss of power to the windlass, check the
“WINDLASS” circuit breaker located on the Breaker
Panel located on the starboard gunwale opposite the
helm (See figure 4.7.1). If the breaker is tripped, reset
the breaker by pushing the lever up. If the breaker
continues to trip, have the anchor windlass system
checked by a qualified marine electrician.
REFER TO THE MANUFACTURER’S MANUAL IN
YOUR OWNER’S MANUAL PACKET FOR COMPLETE
INSTRUCTIONS.
UP
DO
WN