Boston Whaler 280 Outrage, Owner'S Manual

Page: 109 / 161

4-6 280 Outrage
Section 4 • Electrical System
R
Fuse Blocks
There is an electronics fuse
block located in the console
which can be accessed thru
a panel on the aft wall of
the console interior and in
the port side of the hardtop
electronics box.
In the event you need to replace a fuse, use only the
same amperage as the original. It is recommended
that you carry spare fuses.
Use of higher amperage fuses or breakers is a
fire hazard.
Use fuses and breakers having the same
amperage rating as the original or as specified.
!
WARNING
Rigging
Your boat has a large open space between the fuel
tank and the floor to run additional electronic wiring.
Feed the new runs through the rigging boots and
secure it to the existing runs.
If equipped with the optional hardtop, additional
electronic wiring can be routed through the port aft
support of the frame.
Tie another piece of nylon cord to the current
accessory wiring being run and use that for later runs.
Rigging
Fig. 4.6.1
TO CONSOLE
TO ELECTRONICS BOX
1
2
1
2
NAUTIC-ON
TM
Remote Connectivity
(Option)*
Follow the manufacturer’s recommendations for
long term storage of your battery(s).
NOTICE
• 24/7 access to your boat’s information using
the NAUTIC-ON
TM
app.
• Monitor house and engine battery state and
bilge pump activity.
• Review live engine data and diagnostics.
• Track location with smart breadcrumbing
and geofence.
• View weather conditions at the boat.
* A limited subscription is included and thereafter
the service is subscription based.
REFER TO THE MANUFACTURER’S MANUAL
IN YOUR OWNER’S MANUAL PACKET FOR
COMPLETE INSTRUCTIONS AND WARRANTY.
If a fuse is replaced with one of lower amperage, it
will not be sufficient to carry the electrical load of the
equipment it is connected to and will cause nuisance
fuse failure or breaker tripping.
If a fuse is replaced with one of higher amperage,
it will not provide adequate protection against an
electrical malfunction and will create a fire hazard.