All screws and nuts are metric.
FASTENER SPECIFICATIONS:
* 7/8” (22mm) staples require Deep Clinchers
TOOL AIR FITTING:
This tool must use a male free-flow connector plug, 1/4” N.P.T. The minimum inside diameter should be .200”
(5mm). The fitting must be capable of discharging tool air pressure when disconnected from the air supply.
OPERATING PRESSURE:
The operating pressure of the tool is 70 to 100 p.s.i. (5 to 7 kg/cm
2
). Select the operating pressure within this
range for best fastener performance. DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
AIR CONSUMPTION:
Model D62ADC/DS-3219/DS-3522 requires 4.0 cubic feet per minute (.113 cubic meters) of free air to
operate at the rate of 100 fasteners per minute, at 80 p.s.i. (5.66kg/cm
2
). Take the actual rate at which the
tool will be run to determine the amount of air required. For instance, if your fastener usage averages 50
fasteners per minute, you need 50% of the tool's c.f.m. of free air which is required for running at 100
fasteners per minute.
OPERATION
BOSTITCH OFFERS ONE TYPE OF OPERATION FOR THIS SERIES TOOL.
TRIGGER OPERATED
This is a trigger operated model cycled by actuation of the trigger. The trigger operated tool will cycle every
time the trigger is actuated.
-4-
D62ADC/DS-3219/DS-3522 TOOL SPECIFICATIONS
MODEL
LENGTH
HEIGHT
WIDTH
WEIGHT
D62ADC
9" (228mm)
8.625" (219mm)
4.5" (115mm)
5.9 lbs. (2.5 kg)
DS-3219
12.6" (320mm)
8.86" (225mm)
4.5" (115mm)
5.45 lbs. (2.45 kg)
DS-3522
12.6" (320mm)
8.86" (225mm)
4.5" (115mm)
5.45 lbs. (2.45 kg)
MODEL
STAPLE SERIES
WIRE SIZE
CROWN WIDTH
FASTENER RANGE
D62ADC
SWC
.074" x .037"
1-3/8"
1/2" - 3/4"
(1.88 x .94mm)
(35mm)
(12 - 19mm)
DS-3219
B58C / B34C
.074" x .037"
1-1/4"
5/8" - 3/4"
(1.88 x .94mm)
(32mm)
(15 - 19mm)
DS-3522
SW7437
.074" x .037"
1-3/8"
5/8" - 3/4"
(1.88 x .94mm)
(35mm)
(15-19mm)
SW9040
.090" x .040"
1-3/8"
5/8" - 7/8"*
(2.29 x 1.02mm)
(35mm)
(15 - 22mm)
