17
MACHINE SET UP GASLESS MIG WELDING CONTINUED
Connect earth clamp to the work piece
ensuring that the clamp makes good contact
with bare metal.
7
8
5
Re install tip and nozzle to torch and trim wire
to the end of the nozzle.
Switch the machine on using the mains power
switch. Wait a few seconds whilst the machine
powers up
Remove nozzle and tip from torch and press
the wire feed button inside the machine door,
this will feed the wire through the torch.
Release button when wire appears at the end
of the torch.
NOTE: make sure your torch is
straight and has no kinks while you feed the
wire through it.
6
Refer to the chart on the front of the machine,
and set your voltage and wires speed dials to
the according settings, once you start to weld
you can make finer adjustment to suit.
9
NOTE:
It is advisable to run a few test welds
using scrap or offcut materials, in order
to tune the machine to the correct
settings prior to welding the job.
NOTE:
Wire speed will run a full speed when
the trigger is pressed without
making and arc.
Note:
Pictures may vary from your machine model
PART NO.
DESCRIPTION
Knurled Drive Roller For Gasless Wire
RK301019.06.08
Drive Roller 0.6/0.8mm Knurled 30 x 10 x 19mm
RK301019.08.09
*
Drive Roller 0.8/0.9mm Knurled 30 x 10 x 19mm
RK301019.08.10
Drive Roller 0.8/1.0mm Knurled 30 x 10 x 19mm
U Grooved Drive Roller For Aluminium Wire
RU301019.08.10
Drive Roller 0.8/1.0mm U Groove 30 x 10 x 19mm
V Grooved Drive Roller For Solid Wire
RV301019.06.08
Drive Roller 0.6/0.8mm V Groove 30 x 10 x 19mm
RV301019.08.09
*
Drive Roller 0.8/0.9mm V Groove 30 x 10 x 19mm
RV301019.08.10
Drive Roller 0.8/1.0mm V Groove 30 x 10 x 19mm
RV301019.09.10
Drive Roller 0.9/1.0mm V Groove 30 x 10 x 19mm
