17
SHUT DOWN PROCEDURE
WARNING
• Do not ignite the torch near your body, combustible material or close to
regulators and cylinders.
• Caution: the torch can become very hot during and after use, keep away
from skin and combustible materials, lay flat on a clean surface after use.
• Make sure you follow the correct shutdown procedures.
• This equipment uses compressed gas cylinders, do not disassemble
cylinders, puncture or incinerate.
• Always wear the appropriate personal protective equipment when using this
equipment.
• Do not disassemble the regulators, if regulator stops working, contact your
Bossweld agent or Bossweld directly.
• Use only recommended parts with this equipment, altering removing or
using non genuine part can be very dangerous.
• Only use fuel and oxygen cylinders that pass the AS/NZS standards,
compress cylinders can be very dangerous, make sure you follow
manufactures operating instructions.
MAINTENANCE
• Only use Bossweld approved replacement parts
• Do not use this equipment if you are unshore of any procedures outline in
this manuals, contact your Bossweld agent or Bossweld directly.
• Do not use this equipment if part is damage, replace any damaged parts
before use.
• Regularly inspect all parts before use, ensure valves are clean and dry
before connecting to the cylinders.
• Do not disassemble any part of the equipment unless stated in this manual.
• Check equipment for any leaks before ignition of the flame.
