Bossard 035/E32V, Operator'S Manual

Page: 20 / 27

20
EXIT PROGRAM MODE
continued from previous page ...
Adjust value
UP / DOWN
Adjust value
UP / DOWN
Adjust value
UP / DOWN
Adjust value
UP / DOWN
Press until
'LL' displays.
Release to
view value.
Press until
'nS' displays.
Release to
view value.
Press until
'rt' displays.
Release to
view value.
Press until
'rr' displays.
Release to
view value.
Press until
'rS' displays.
Release to
view value.
Toggle value
The final option displayed will
be dependent on the settings
of 'Rc', 'LL' and 'rt'. Once the
final value is adjusted, press
SELECT to return to normal
operation.
(LL) Re-Hit Screw Time
Programming of the (LL) value is only avai-
lable if Slow Start Time (RC) is set to 0.0
(slow start off). The re-hit function can't be
used in conjunction with slow start.
(rt) Auto-Reverse Time
Entering a value greater than 0.00 for
auto-reverse time will cause the driver to
reverse after the clutch trips for the preset
amount of time. 'LL' must be set to 0.00 for
the 'rt' function to be available.
(rr) and (rS) Reverse / Pause / Tighten
Entering a value greater than 0.00 for 'rr'
will start the cycle with a timed reverse
('rr' value), then forward until the clutch
activates.
Note:
- FWD/REV switch must be in REV position
for the function to work.
- 'LL' and 'rt' must equal 0.00 for the 'rr' to
be available.
(nS) Disable Screwdriver on 'NG'
If 'nS' is set to y (yes), the screwdriver will be disabled after a
no good (NG) rundown. The operator must confirm by pressing
the SELECT key, or an external confirm signal must be input
through the I/O. (applies to forward cw rotation only).
3 Digit Time Values
The values for Lt, LL, rt, rr and rS are 3-digit time
values in seconds with a format of
x.xx .
To view/edit the entered value, toggle left and right
using the 'ON/CLEAR' button. The position of the
decimal point on the screen indicates whether you are
viewing the 'ones' and 'tenths' digit, or the 'tenths' and
'hundredths' digits respectively.
Note that the 'tenths' digit appears on both screens.