Bossard 035/E32V, Operator'S Manual

Page: 9 / 27

9
3.6 GENERAL SCREWDRIVER LAYOUT
1) 2) 3)
4) 5) 6) 7)
1) Torque Adjusting Nut
Turn CW to increase torque setting, CCW to decrease torque output. Higher values on scale indicate a
higher torque setting. Please note – numbers (1-8) on the scale are for
reference only and are not actual torque values.
2) Start Lever
Press to start the screwdriver and hold until the driver shuts off (CW tightening).
3) Suspension Bail
Use the bail to hang the screwdriver from a tool balancer.
4) Bit Holder
Retract sleeve to Insert/remove bits/tool is inserted, release the sleeve, and pull back and forth on the bit/
tool to verify retention
5) Housing Nut
Remove the housing nut to install a torque locking sleeve. The lock sleeve covers the torque adjusting nut
to deter unintentional changes to the adjustment
6) FWD/REV Switch
Select the desired direction of rotation for the screwdriver - FWD (CW) or REV (CCW) Some models also
have an OFF position.
7) Tool Cable Connection
Align the pins of the cable with the socket and push the cable’s connector firmly into place. Carefully hand
tighten the securing ring – do not overtighten.