Boss Snowplow MSC13960, Owner'S Manual

Page: 7 / 16

Product Overview
Controls
g037041
Figure 10
1. A-frame switch
2. Angle switch
•
Move the left switch up or down to raise or lower
the plow.
•
Move the right switch left or right to angle the plow.
Kickstand
g037042
Figure 11
1. Kickstand spring pin
The kickstand keeps the plow upright for ease of
mounting and storage. To raise or lower the kickstand,
pull the kickstand spring pin and move the kickstand
to the desired position. Release the spring pin to lock
the kickstand in place.
Operation
Mounting the Plow
Note:
You must first install the Grandstand Low Flow
Hydraulic and Quick Attach kits before mounting the
plow.
1. Ensure that the plow is sitting upright, with the
kickstand lowered (
Figure 12 ).
g334233
Figure 12
1. Plow coupler 3. Coupler pin
2. A-frame coupler
2. Lower the A-frame on the machine completely;
refer to
Controls (page 7) .
3. Slowly drive forward until the A-frame coupler
contacts the plow coupler (
Figure 12 ).
4. Raise the A-frame until the coupler pin locks into
place (
Figure 12 ).
5. Lower the A-frame until the plow rests on the
ground.
6. Shut off the machine engine, wait for all moving
parts to stop, engage the parking brake, and
remove the key.
7. Connect the angle-cylinder hydraulic hoses to
the quick disconnects on the machine (
Figure
12 ).
8. Raise the kickstand.
9. Start the machine and use the controls to move
the plow in all directions to ensure that the plow
is functioning normally.
Removing the Plow
1. Park the machine on a level surface, shut off the
engine, wait for all moving parts to stop, engage
the parking brake, and remove the key.
7