Maintenance
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 2 hours
• Tighten all hardware.
Before each use or daily
• Check the hydraulic cylinders.
• Check the hydraulic lines and hoses.
• Check the hydraulic-fluid level; refer to your Grandstand Multi Force
Operator’s
Manual
.
• Check the wire harness connectors.
• All fasteners, pins, retainers, nuts, and bolts.
• Check the cutting edge for wear.
Before storage
• Grease the hydraulic cylinder rods.
Monthly
• Apply dielectric grease to the wire harness connectors (during plowing season).
Yearly
• Replace the hydraulic fluid; refer to your Grandstand Multi Force
Operator’s Manual
.
Maintenance
•
Check the hydraulic lines and hoses daily for
leaks, kinked lines, loose mounting supports, wear,
loose fittings, weather deterioration, and chemical
deterioration. Make all necessary repairs before
operating.
•
Check the hydraulic cylinders daily for leaks, rust,
or pitting on the rods. Make all necessary repairs
before operating.
•
Check the wire harness connectors daily for
corrosion and damage.
•
Apply dielectric grease to the wire harness
connectors monthly, during plowing season.
•
Check the cutting edge daily for wear. If the cutting
edge is worn down either flip or replace it; refer to
Flipping or Replacing the Cutting Edge (page 9)
.
•
Check all fasteners, pins, retainers, nuts, and bolts
daily to ensure that they are secure. Torque them
to the appropriate value if they are loose.
Flipping or Replacing the
Cutting Edge
The urethane cutting edge wears down over time, but
can be flipped for extended use. Once the cutting
edge has been worn down past the logo, it must be
flipped (
). If the cutting edge has already
been flipped, replace the cutting edge; contact an
authorized BOSS dealer for more information.
g037044
Figure 14
1.
Wear line
1.
Remove the bolts, washers, top locknuts, and
metal strap securing the urethane cutting edge
to the bottom of the plow.
2.
Flip the cutting edge over.
Note:
If the cutting edge has already been
flipped, discard it and use a new edge.
3.
Secure the metal strap and cutting blade to the
plow using the previously removed hardware
(
).
Note:
Do not tighten the bolts and locknuts at
this time.
9
Summary of Contents for MSC13960
Page 12: ...Schematics g037075 Electrical Schematic Rev 0 12...
Page 14: ...Notes...
