background image

CORDLESS

BLOWER KIT

INSTRUCTION MANUAL

SPECIFICATIONS

Voltage:  

18V

Battery: 

 

4.0Ah Li-ion

Charge Time: 

80 min

No Load Speed: 

  12,000/min

Max. Air Speed:  

  210km/hr

Weight: 

 2.0kg

PXCBLK-418

WHAT’S IN THE BOX

Cordless Blower

4.0Ah Battery & Fast Charger

IN ORDER TO MAKE A CLAIM UNDER THIS WARRANTY YOU MUST 

RETURN THE PRODUCT TO YOUR NEAREST BUNNINGS WAREHOUSE 

WITH YOUR BUNNINGS REGISTER RECEIPT. PRIOR TO RETURNING 

YOUR PRODUCT FOR WARRANTY PLEASE TELEPHONE OUR CUSTOMER 

SERVICE HELPLINE:

Australia 1800 069 486
New Zealand 0508 069 486

WARRANTY

TO ENSURE A SPEEDY RESPONSE PLEASE HAVE THE MODEL 

NUMBER AND DATE OF PURCHASE AVAILABLE. A CUSTOMER 

SERVICE REPRESENTATIVE WILL TAKE YOUR CALL  

AND ANSWER ANY QUESTIONS YOU MAY  

HAVE RELATING TO THE WARRANTY POLICY  

OR PROCEDURE.

OZITO 

Australia/New Zealand (Head Office) 1-23 Letcon Drive, Bangholme, Victoria, Australia 3175.

The benefits provided under this warranty are in addition  
to other rights and remedies which are available to you at law.
Our goods come with guarantees that cannot be excluded  
at law. You are entitled to a replacement or refund for a major failure and for 
compensation for any other reasonably foreseeable loss or damage. You are also 
entitled to have the goods repaired  
or replaced if the goods fail to be of acceptable quality and the failure does not 
amount to a major failure. 
Generally you will be responsible for all costs associated with  
a claim under this warranty, however, where you have suffered  
any additional direct loss as a result of a defective product you  
may be able to claim such expenses by contacting our customer service helpline 
above.

ozito.com.au

0217

WARNING

The following actions will result in the warranty being 

void.

• 

 If the tool has been operated on a supply voltage other  

than that specified on the tool.

• 

 If the tool shows signs of damage or defects caused  

by or resulting from abuse, accidents or alterations.

• 

 Failure to perform maintenance as set out within the instruction manual.

• 

 If the tool is disassembled or tampered with in any way.

5 YEAR REPLACEMENT WARRANTY

Your Product is guaranteed for a period of 60 months from the original date of 
purchase and is intended for DIY (Do It Yourself) use only. If a product is defective it 
will be replaced in accordance with the terms of this warranty. 

Lithium Ion 

batteries and chargers are covered by a 36 month 
warranty. 

Warranty excludes consumable parts, for example: blower tube.

Summary of Contents for POWER X CHANGE PXCBLK-418







Reviews: