g318431
Figure 23
5.
Add or remove blade-adjustment shims; refer to
and
6.
Install the bumper stop nut and washer.
7.
Rotate the center section and blades back to the
normal operating position.
8.
Align the trip spring eye bolts through the spring
plate and loosely install 2 trip spring bolts and
washers.
9.
Tighten the nuts until 13 mm (1/2 inch) of the
trip spring bolts extend beyond the top of the
adjustment nuts.
g318529
Figure 24
1.
13 mm (1/2 inch)
10.
Attach the plow; refer to
(page 13)
.
11.
Lower the blade all the way to the ground; refer
to
Controls (page 10)
.
12.
Check the edges of the blades to ensure they
lay flat against the ground. If not, repeat this
procedure as needed.
Checking the Hydraulic
Fluid Level
1.
With the plow mounted to the vehicle, lower the
plow to the ground and ensure that it is in the
straight position.
2.
Remove the 4 plastic rivets securing the coupler
cover to the coupler, and remove the cover
(
).
g318526
Figure 25
3.
Ensure that the fluid comes up to the fill line
on the side of the tank (
). If it does
not, add more hydraulic fluid; refer to
Hydraulic Fluid (page 17)
.
g318527
Figure 26
16
