OT
O
B
T M
O
B
O
TT
M
- DIN REAR-MOUNT (METHOD B)
Installation using the screw holes on the sides of the unit.
Fastening the unit to the factory radio mounting bracket.
1. Select a position where the screw
holes of the bracket and the screw
holes of the main unit become
aligned (are fitted) and tighten the
screws at 2 places on each side.
2. Screw
3. Factory radio mounting bracket.
4. Dashboard or Console
5. Hook (Remove this part)
Note:
The mounting box, outer trim ring,
and half-sleeve are not used for method
B installation.
5
2
4
3
2
5
a. Frame
b. Insert fingers into the groove in the
front of frame and pull out to remove
the frame. (When re-attaching the
frame, point the side with a groove
down wards and attach it.)
c. Insert the levers supplied with the
unit into the grooves at both sides of
the unit as shown in figure until they
click. Pulling the levers makes it
possible to remove the unit from the
dashboard.
- Trim Plate Installation:
Removing the unit
a
b
c
- PANEL OPEN / CLOSE OPERATION
1
1. Press Open button
2. The CD slot will be accessible.
3. After CD is loaded or unloaded return
the panel to its original position.
Before attaching the trim plate, the side with a "Bottom" Label stuck
should be at down side (as shown on diagram).
Push the trim plate against the main panel until it is fitted.
E - 3
Note:
Before inserting or ejecting disc,
press the Release button to flip down the
faceplate.
Open
button
N
C
I
D
SE
R
T
E
2
Summary of Contents for 820UA
Page 1: ...24 10 R 03 0500...
