Bose S1 Pro Page 2 User Manual Download

Page: 2 / 192

2 - Important Safety Instructions

Important Safety Instructions

This device complies with part 15 of the FCC Rules and with Industry Canada license-

exempt RSS standard(s). Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

Bose Corporation hereby declares that this product is in compliance with the

essential requirements and other relevant provisions of Directive 2014/53/EU

and all other applicable EU directive requirements. The complete declaration of

conformity can be found at:

www.Bose.com/compliance

Frequency band of operation 2402 to 2480 MHz.

Bluetooth: Maximum transmit power less than 20 dBm EIRP.

Bluetooth Low Energy: Maximum power spectral density less than 10 dBm/MHz EIRP.

This product meets all EN55103-2 immunity requirements for E2 electromagnetic

environment.

This equipment should be installed and operated with a minimum distance of 20 cm

between radiator and your body

Shielded cables are required to maintain regulatory compliance

Changes or modifications not expressly approved by Bose Corporation could void the

user’s authority to operate this equipment.

Information About Products That Generate Electrical Noise (FCC Compliance Notice

for US)

Note: This equipment has been tested and found to comply with the limits for a Class

A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference when the equipment is

operated in a commercial environment. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with

the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference

in which case the user will be required to correct the interference at one’s own

expense.

Management Regulation for Low-power Radio-frequency Devices

Article XII

According to “Management Regulation for Low-power Radio-frequency Devices”,

without permission by the NCC, any company, enterprise, or user is not allowed to

change frequency, enhance transmitting power, or alter original characteristics, as well as

performance, to an approved low power radio-frequency device.

Article XIV

The low power radio-frequency devices shall not influence aircraft security and

interfere with legal communications; If found, the user shall cease operating

immediately until no interference is achieved. The said legal communications means

radio communications in compliance with the Telecommunications Act.

The low power radio-frequency devices must be susceptible with the interference from

legal communications or ISM radio wave radiated devices.

• All Bose products must be used in accordance with local, state, federal and

industry regulations. It is the installer’s responsibility to ensure installation of the

product is performed in accordance with all applicable codes, including local

building codes and regulations. Consult the local authority having jurisdiction

before installing this product.

• To reduce the risk of fire or electrical shock, do NOT expose the product to rain,

liquids, or moisture. Not applicable for products rated IPX4-9.

• Do NOT expose this product to dripping or splashing and do not place objects

filled with liquids, such as vases, on or near the product. Not applicable to

products rated IPX4-9.

• Keep the product away from fire and heat sources. Do NOT place naked flame

sources, such as lighted candles, on or near the product.

• Do NOT use a power inverter with this product.

• Do NOT use in vehicles or boats.

• Do NOT make unauthorized alterations to this product.

• Do NOT expose products containing batteries to excessive heat (e.g. from storage

in direct sunlight, fire, or the like).

• The battery accessory provided with this product may present a risk of fire or

chemical burn if mishandled.

• Where the mains plug or appliance coupler is used as the disconnect device, the

disconnect device shall remain readily operable.

• Only use genuine Bose batteries with this product. Contact Bose customer service

for replacement batteries.

• Do NOT use the Bose S1 Pro system with a tripod/stand that is unstable. The

loudspeaker is only designed for use on a 35 mm post, and the tripod/stand must

be capable of supporting a speaker with a minimum weight of 7 kg (15 lbs) and an

overall size of 241 x 279 x 330 mm (9.5 x 11 x 13 inches). Using a tripod/stand that

is not designed to support the size and mass of the S1 Pro system may lead to an

unstable and hazardous condition that could result in injury.

Charging temperature range: 0°C - 42°C (32°F - 108°F)

Discharging temperature range: –20°C - 45°C (–4°F - 113°F)

1.  Read these instructions.
2.  Keep these instructions.
3.  Heed all warnings.
4.  Follow all instructions.
5.  Do not use this apparatus near water.
6.  Clean only with a dry cloth.
7.  Do not block any ventilation openings. Install in accordance with the

manufacturer’s instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves,

or other apparatus (including amplifiers) that produces heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plug. A

polarized plug has two blades with one wider than the other. A grounding-

type plug has two blades and a third grounding prong. The wider blade or

third prong is provided for your safety. If the provided plug does not fit in

your outlet, consult an electrician for replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched, particularly

at plugs, convenience receptacles, and the point where it exits from the

apparatus.

11. Only use attachments/accessories specified by the manufacturer.
12.

Use only with the cart, stand, tripod, bracket, or table specified by

the manufacturer or sold with the apparatus. When a cart is used,

use caution when moving the cart/apparatus combination to avoid

injury from tip-over.

13. Unplug this apparatus during lightning storms or when unused for long

periods of time.

14. Refer all servicing to qualified personnel. Servicing is required when the

apparatus has been damaged in any way such as power-supply cord or plug

is damaged, liquid has been spilled or objects have fallen into the apparatus,

the apparatus has been exposed to rain or moisture, does not operate

normally, or has been dropped.

For Denmark, Finland, Norway, and Sweden:

English: Provide an earth connection or ensure the socket outlet incorporates a

protective earthing connection before connecting the plug to the mains socket outlet.
Danish: Apparatets stikprop skal tilsluttes en stikkontakt med jord, som giver

forbindelse til stikproppens jord.
Finnish: Laite on liitettävä suojamaadoituskoskettimilla varustettuun pistorasiaan.
Norwegian: Apparatet må tilkoples jordet stikkontakt.
Swedish: Apparaten skall anslutas till jordat uttag.

Please read and keep all safety and use instructions.

This symbol means the product must not be discarded as household

waste, and should be delivered to an appropriate collection facility for

recycling. Proper disposal and recycling helps protect natural resources,

human health, and the environment. For more information on disposal

and recycling of this product, contact your local municipality, disposal

service, or the shop where you bought this product.

Part Name

Toxic or Hazardous Substances and Elements

Names and Contents of Toxic or Hazardous Substances and Elements

PCBs

Metal parts

Plastic parts

Speakers

Cables

This table is prepared in accordance with the provisions of SJ/T 11364.
0: Indicates that this toxic or hazardous substance contained in all of the homog-
enous materials for this part is below the limit requirement of GB/T 26572.
X: Indicates that this toxic or hazardous substance contained in at least one of
the homogenous materials used for this part is above the limit requirement of
GB/T 26572.

Lead

(Pb)

Mercury

(Hg)

Cadmium

(Cd)

Hexavalent

(CR(VI))

Polybrominated

Biphenyl (PBB)

Polybrominated

diphenylether